Burkert Type 8045 Uživatelský manuál stáhnout pdf (Strana 14)

Installation and wiring

Type 8045

Correct

flow direction

Incorrect

Correct Incorrect

Fig. 7: Air bubbles within the pipe

→ If necessary, use a flow conditioner to improve measurement

precision.

7.3. Installation into the pipe of a

8045 with a G2'' nut

In order to ensure a high accuracy of the measurements and

good stability of the „flow zero“ point, install the device into

the processed medium at least 24 H before calibration.

→ Install the S020 fitting into the pipe taking into account the rec-

ommendations in chap. 7.2.

→ Check that there is a seal on the fitting and that it is not damaged.

Replace the seal if necessary.

→ Check that there is a seal (see mark 6, Fig. 8) on the flow sensor.

→ Insert the nut (see mark 3, Fig. 8) on the fitting.

→ Insert the snap ring (mark 2 Fig. 8) into the groove (mark 5 Fig.

8).

→ Position the arrow on the side of the device in the direction of the

flow: the totalizers will increment.

→ Insert the device (mark 1 Fig. 8) into the fitting.

→ Tighten the nut (mark 3, Fig. 8) by hand on the device.

English

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 97 98

Žádné komentáře

Burkert Type 8045 Uživatelský manuál Strana 14